data supllier bridge need help configure

[Former Member]

hello evry body

i am using sneak preview 2004s sp9

my jco button is disabled

i am unable to find data supplier bridge

i went through lot of blogs but unable find solution

[i followed this

link|https://www.sdn.sap.com/irj/sdn/weblogs?blog=/pub/wlg/2167] [original link is broken] [original link is broken] [original link is broken];

in step 9

but unable to find data supplier bridge page

and i went visual admin

sld data supplier

i found

http settingd

cim client settings

but unnable to find

RFC settings tab

some plz give me a solution with detail steps

[Former Member]

If the JCO button is disabled then it means that the SLD is not configured yet.Is it configured?

[Former Member]

yes i need help in configuring sld portal and r/3

i am using sneak preview sp9 amd ecc 5.0

but i am unnable to find rfc settings tab in visual admin (visual admin -sld datasupllier -there is no rfc setting tab to specify the gate way )

so i tried this doc plz see link below

/people/sugree.phatanapherom/blog/2005/08/14/configuring-sld-in-sneak-preview-sap-netweaver-04-sneak

i am stuck at step 9

in sld ->adminnistration ->data supllier i am unable to find rfc settings to configure the bridge

plz try to give me details steps to dod this

[Former Member]

You probably don't need a bridge. You only need a bridge if you want this SLD to forward its information to another SLD in the system landscape.