on 02-07-2008 1:05 PM
Hi Friends
I am stuck up in this problem have gone through the blogs but of no use...
Actually I am working on a Idoc to File scenario and sometime before a scenario which was working fine stop working after a small change in the mapping.
I am unable to get the file in my target system even though there is no error in the IR and ID .
In the RWB it is showing me no error but the component Monitoring is showing the status as "HOLDING"
I have removed the messages with status system error and now there are only 2 types of status one is HOLDING and another is SUCCESSFUL.
Any help would be surely rewrded with points.
Thanks and Regards
Hi,
Actually the problem is not in XI side, it is at receiver end.
Possible cause of holding status.
1. If you are sending a text file then check your FCC parameters. As you said it was working fine, but after you made some changes in mapping and form then it is not working.
Check if you have added or removed any field in mapping the FCC will change accordingly.
2. It may happen that Receiving System is not available/up. Plz chk this too.
Regards,
Sarvesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please look at you queues smq2 and verify if queues are scheduled smqr and sxmb_adm.
/wg
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.