on 02-05-2008 1:10 PM
i want see the results of some MIC say length of rod for last 10 lots in graphical view.
how can i?
Hi,
if your problem is yet to solved
pl follow the following steps
1. set indicator SPC & Sampling Procedure in MIC control indicator
2.Define SPC Criteria 02 or 03 as per requirement
3. Define Control Chart Type (use standard first)
4. define sampling procedure as per requirement
5.Assign MIC To Inspection Plan and also sampling procedure and control chart type
6. result recording after getting inspection lot
7.you can see the control chart using T.code QGC1
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi ,
Try this , QGP1 - Inspection results for Task list characteristic.
Give the task list details / characteristic etc.
It will give the results of that char's for all lots for the selected period.
This will give the results , only for that Task list char.
Regards
K.M.Arun
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
You can do this in QE02 with the histogram. But to run this chart you need to have the following pre-requisites.
1.The confirmation of measured values must be supported.
2.Individual results or classed results must be supported.
3. At least one valid value must have already been recorded.
Hope this helps.
Prakash
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
CHECK THE TYRANSACTION QGC3 WHICH WILL GIVE THE RESULTS FOR PERIOD FOR I MIC.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.