on 01-29-2008 10:30 AM
HI ABAPERS
i need driver program for this form.
thnks
pardeep
Edited by: pardeep kumar on Jan 29, 2008 4:00 PM
go to se11 and give TNAPR table
and say display then press ControlshiftF10
in the SFORM tab give the above form name and press F8
you will get the corresponding program.
You will only get if it is configured against that print program in the NACEansaction
generally the configuration for standard forms would be there
Regards,
Nageswar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi
good
When you will create the LOGO node in the smartform. there is CONDITION tab you can put your condition there.
Create 4 Logo node in your smartform at the same position and in each logo node put the condition in the condition Tab. IF sy-uname = 'UNAME1' then LOGO UNAME1 will be called do it forall the logos.
thanks
mrutyun^
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Pardeep,
The print program is
/SMB40/FM06P .
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.