how log on to the Integration server host with the user XISUPER - post inst

[Former Member]

Hi,

Can anyone please help me to execute the following post installation steps?

1.You must now log on to the Integration server host with the user XISUPER, to switch the initial password to a valid password.

2.You must restart the J2EE engine to transfer the user creation to the J2EE immediately.

Thanks

[Former Member · Accepted solution]

You need to follow the necessary steps in the correct order from the configuration guide:

https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/ac6de690-0201-0010-54ac-8923089d...

These are the post installation steps for XI to run correctly. If you need any help with the configuration, just post your question here so I can help you. Also, after you finish configuration, follow this SAP note to check if your XI works correctly:

Note 817920 - XI Readiness Check Version 3

Regards,

Gökhan

[Former Member]

Hi,

Which version of the Netweaver have you installed? 2004, 2004s(Netweaver 07) or Netweaver 7.1?

[Former Member]

Hi,

My component version is Netweaver 2004.

Please clarify me how to proceed the post installation steps.

Thanks,

Bala Raja

[Former Member]

Hi,

To log on to Integration server host you need below roles.

Before you can start to configure usage type PI, you have to assign yourself (and all those involved in the configuration process) the following roles on each host (SAP NetWeaver application server) that is involved:

● SAP_XI_ADMINISTRATOR (mandatory)

● SAP_XI_CONFIGURATOR (mandatory)

● SAP_SLD_ADMINISTRATOR (mandatory for the SLD configuration)

● SAP_SLD_CONFIGURATOR (mandatory for the SLD configuration)

Now Post Installation Steps

https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/419b479b-0801-0010-f8a1-c26208b4...

Thnaks

Swarup