on 01-24-2008 5:02 AM
My problem is I Choose 100% Inspection Sample Procedure Is 100%
When I Go To Result Recording ,I have lot of 20 nos the Sample are 20but ICan Do Recording For Only 15 nos What setting I Do To Record Results For 20 Nos .
Please Mail me At Sanjay4350@gmail.com
Regards
Sanjay
I think you need to check the following -
Select the characteristic under consideration in QP02.
Go to the sampling procedure.
In sampling procedure, check the sampling type - whether it is 100% or fixed sample or % sample.
Then check the sample tab where I doubt you will find 75%.
To check this try another lot size of 40 pieces and see the sample size you get.
This shall give you result or a lead to another solution.
Please reply,
Regards,
Narendra Lohokare.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
sanjay,
just doble click on that characteristic in result recording screen and you will be able to do the recording for all the samples.
hope this helps.
reward points and close the thread.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
change the qty from 20 to 5 and 20 to 40 amd see the result and come back...i think it is because of table control...
Use QE51n transaction and try
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.