No receiver found - Scenario works fine in Test in Integration Directory

[Former Member]

Hello Everyone,

I'm receiving the following in SXMB_MONI when I run my xmlFile to RFC scenaro:

... (10 lines)

I have tried the following to remedy this:

- CPA Cache Refresh

- SXI_CACHE refresh on ABAP

- Repository, Runtime, and Directory Cache refreshes (ALL).

Please help! I do appreciate your time and help on this issue.

Regards,

John

[agasthuri_doss · Accepted solution]

Hi,

check you RD Condition for your Business System and check your configured correct Service and receiver for your System in ID.

This will help you

/people/paul.medaille/blog/2005/06/24/test-your-xi-configuration-with-the-new-test-tool

Regards

Agasthuri Doss

[Former Member · Accepted solution]

Hi Agasthuri,

Thanks for your reply. I believe you have me headed in the right direction. Excuse my mind being blank right now, but can you elaborate on RD? What does this mean?

Thanks so much!

John

[agasthuri_doss · Accepted solution]

Hi john,

RD- receiver Determination.

Regards

Agasthuri Doss

[Former Member · Accepted solution]

Hi Agasthuri,

RD looks good as well my friend

I'm not sure what is causing this but I'll continue to look...

Thanks,

John

[agasthuri_doss · Accepted solution]

Hi John,

Can you check the Sender Agreement and is your Scnerio Async ?

Check the Connection between XI and R3.

Regards

Agasthuri Doss

[ravi_raman2]

John,

i would look to see if you can connect to the r/3 system..to send a message...so as Agasthuri pointed out..it could be an issue after the reciever was determined and if that did not point to a system...failed

ID test is just a test run..nothing is being sent.

Regards

Ravi Raman