How to configure different interface mappings

[Former Member]

Hi,

I have a sceanrio in which an EDI message will be sent to XI. This EDI message will be processed by one of two different interface mappings. How should this be configured in XI.

Should I have two different send actions in the Integration Scenario to handle the different interface mappings.

[prabhu_s2 · Accepted solution]

in the IP u will use a recv step to recv the message and a switch step that would route the message to coresponding brach based on the condition set. in each brach have the transformation step that would carry appropriate interface mapping (abs)

[Former Member · Accepted solution]

Do I need to use an IP for it though.

[prabhu_s2 · Accepted solution]

routing the message based on condition (4 processing by one of two different interface mappings) u wud need an IP

Edited by: Prabhu S on Jan 4, 2008 11:23 AM

[former_member184619]

Hi Martin,

In IS you only define send and receive steps... I think you have to Use IP for your purpose....

Check my reply in this thread

Sachin