MICR Code

[former_member187457]

Hi All

I want to use MICR font....in script

so for printing shld i have to use special charaters or ...i can write only normal number.....

i want to print

&check_no& &Acct_no& &bank_key&

i have assigned MICR_E font for following fields.......

Plz help me.....

Thnx

Rohit

[KalC · Accepted solution]

HI Rohit,

It depends on the printer that you are using.Some printers may not support this font.Install new MICR font if it is not there in your printer fonts through transaction SE73.

Regards,

Kalyan.

[former_member187457 · Accepted solution]

is any thing to do with SAP ......as in ecc 6.0 micr fonts are thr ,......if it is not installed in printer then even it shld display in print preview.....am i rit...??????

will it display or not......

[Former Member · Accepted solution]

Hi,

Define a paragraph format with font in MICR_E family.

Use this paragraph format where u want to display the text in MICR format.

e.g: i have used the following while desiging cheque layout for our customer.

D2--> REGUD-CHECT&C &gv_start(C)&D&gv_end(C)&A &reguh-ubknt&C

in the above, D2 is a paragraph format of MICR_E family.

Hope it helps.

reward points if helpful.

[former_member187457 · Accepted solution]

Hi AH

i have used Character as MICR font...and paragraph as default paragraph...

can tht make the diffrence.......

[Former Member · Accepted solution]

Yes. According to my knowledge it should make difference.

Try creating a paragraph format and then check again.

Hope it helps.

[himayan_das2]

Hi Rohit,

Did u get ur MICR printing in check sorted out?? if so how?? I m also facing a similar issue..KIndly help thanks..

[former_member187457]

no dude its still pending....

i think we have to install printer....for tht....

lets c...

[Former Member]

For SAPscript, this is strictly a hardware issue. Your printer must have a MICR font installed. Either in the printer memory or you must buy a font memory card to be installed in your printer.

You can validate if your printer has a MICR font by going in to the printer settings and print the font diagnostic. The MICR font must be shown. If it does not, your SAPscript will never print.

[amit_khare]

You just need to use that as a character format to display the values using normal format.

Regards,

Amit

Reward all helpful replies.

[former_member187457]

i am using MICR font but....bt is not printing in MICR font....

[Former Member]

it depends upon the fonts installed in u r system.

u will pass font and ctc.. in to CHAR format..