on 12-31-2007 11:40 AM
Dear Experts,
I need to confirm following things in case of calibration::
1. In case of calibration we will use same control key = PM01 ??
2. Do we need to enter sampling procedure and inspection method??
plz help
rgrds
DM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi
For calibration inspection you can use PM01 ,but for characteristic to be created for inspection lot then you have to use QM* control key
inspection characterisitic and sampling procedure is must but inspection method is option
regards
thyagarajan
In case of PM01,,,Sampling procedure is must or not???
Thxs a ton
Deepak
in case of PM01 it is not required, since it is not used for characteristic evaluation
For calibration Order type in IMG settings we have to configure QM01 or PM01 ? I have little doubt.
Do tell the impact of both?
Thanks
Edited by: Deepak M on Jun 12, 2008 3:29 PM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.