on 04-13-2004 11:25 PM
Could someone give me an example of the values that should be in the R/3 table SPROXSET so that I can configure the connection for ABAP proxy generation using transaction SPROXY?
Thanks
Patrick
IFR_ADDRESS host:8000/rep
IFR_PASSWORD XIPASS
IFR_USER XIAPPLUSER
HTH.
Pandari
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi!!!
As far as I remember I didn't have to do any additional settings.
Please double check if you put the correct values from Exchange Profile (http://<host>:<port>/exchangeProfile) into SPROXSET table.
You can also check it using the following programs:
SPROX_CHECK_IFR_ADDRESS
SPROX_CHECK_IFR_RESPONSE
SPROX_CHECK_IFR_CONNECTION
Have a nice day,
Andrzej Filusz
Hi Andrez,
Thanks for the prompt reply.
We have done the required setting in Exchange Profile as described in post installation guide.
Do we need to manually update SPROXSET table. If yes, please can u tell us from where can we get the values for updating in the table.
We checked the program given below.
SPROX_CHECK_IFR_ADDRESS
For the two described below, when we execute the program, it prompts for user id and password. When we put the user id and password it generates an XML page. But when we run it again it again prompts for the user id and password.
SPROX_CHECK_IFR_RESPONSE
SPROX_CHECK_IFR_CONNECTION
Thanks for all the help.
Regards
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.