IDX2 doens't refresh IDoc structure

[Former Member]

Hello everybody,

I have a problem with the IDX2. There is a Z IDoc which has changed. So I deleted the old entry in the IDX2 and load it again from the system. But the structure is not refreshed. I tryed to load it from another XI System (the development XI and not the quality XI) but from the same R/3 backend. And there the structure is refreshed. So it seems to be a problem of the XI and not the R/3 backend.

We are on NW04s SPS 13.

Did anybody know this problem and can help me.

Thanks

[turmoll · Accepted solution]

Hi,

In SAP XI 3.0 SP >= 17 there is a report: IDX_CHECK_METADATA which compares/deletes matadata.

In SAP XI 3.0 SP < 17 there is a report IDX_RESET_METADATA which deletes matadata.

Regards,

Jakub

[Former Member · Accepted solution]

Thanks a lot Jakub, the IDX_RESET_METADATA helps me.

Now the structure is correct

[Former Member]

Hi,

Check whether the port is correctly configured in IDX1. Make sure it is working.

Regards,

Divija.

Edited by: Divija KN on Dec 18, 2007 1:49 PM

[Former Member]

Hi,

Following two should solve your problem:

Goto IDX1 edit port and then save it again it will refresh connection b/w R/3 and XI.

Goto IDX2 delete metadata and import Idoc again.

You can also refer to note: 907957 (not sure as you are already on higher patch)

Regards,

Gourav

---

Reward points if it helps you