Give me full details of Dynamic Configuration for file

[Former Member]

Hi all,

please provide details of Dynamic Configuraion for file.

Thanks and regards

sai

[Former Member · Accepted solution]

Hi,

Refer the below weblog

/people/michal.krawczyk2/blog/2005/11/10/xi-the-same-filename-from-a-sender-to-a-receiver-file-adapter--sp14 - The same filename from a sender to a receiver file adapter - SP14

And <b>check for the Communication channel settings how to do for Sender & Receiver File channels</b>, Dynamic configuration Code is also available in the weblog.The same code you can use in your UDF and map the output of your udf to one of u r target field.

By following this you can able to set the receiver file name as same is of your file name of Source.

Hope it will helps to solve u r problem.

Cheers

Veera

[Former Member]

Hi,

Go through this blog

/people/michal.krawczyk2/blog/2005/11/10/xi-the-same-filename-from-a-sender-to-a-receiver-file-adapter--sp14

[Former Member]

Hi

With XI 3.0 SP14, some paramters in the Integration Directory's Communication Channel can be dynamically determined during runtime. A couple of examples are the filename and directory used by the File Receiver Adapter. The values for filename and directory can be obtained from the payload of the XML message.

Please go through the following blog

<b>/people/william.li/blog/2006/04/18/dynamic-configuration-of-some-communication-channel-parameters-using-message-mapping

Thanks

Abhishek

**Please Reward points in case helpful****