on 12-05-2007 7:13 AM
hi experts,
tell me about the IDOC Fields and its Creation.
(Where to define
Reciever Port, Partnernumber
Sender Port, Partnernumber
actually i created one and for all the fields, but when i tried with those it shows status message as 37 ( Sender port)
<i>help me to resolve this</i>
tell me how the entire system <b>( of outbound idoc) </b>works
thanks in advance
nikhilbos
Hi,
This is expalined both the scenarios:
Please follow the below process for configuration:
Pre-requisites for Inbound IDoc to R/3 from PI:
Configuration required at Xi side:
Go to IDX1: configure the port.
Go to IDX2: load the DOC metadata.
Go to SM59: Create RFC destination which points to R3 system this is require in the case where your IDOC is sent to R 3 system,
Configiration required at R3 side:
Maintain Logical System for PI (SALE transaction):
Maintain Partner Profile for XI system(WE20):
Pre-requisites for Outbound IDoc from R/3 to PI:
Configurations required in R/3:
Maintain Logical System (SALE)
Define RFC Destination (SM59) which points to PI system
Maintain Port (WE21)
Maintain partner profile. (WE20):
Maintain Distribution Model (BD64):
Also refer ALE configuration for pushing idocs from SAP to XI
/people/swaroopa.vishwanath/blog/2007/01/22/ale-configuration-for-pushing-idocs-from-sap-to-xi
Thnx
Chirag Gohil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi Gohil,
tell me, for R/3 to PI
IDOC Header
1. What specifies the sender Port and Partner number <i> is that the same R/3 system or it needs to be configured in the PI</i>
2. In PI, we have to define the same port or want. And What about the Partner number in the PI s Reciever status of messege
<i> i am bit confused with the Sender Port and Partner Number ( in the IDOC Header) </i>
thanks again
nikhil
hi Gabriel,
thanx.
I have created all the configurations in R/3 and PI. The status is set to 37 in WE02 and shows an error that 'IDOC was saved but not send'. but at times, it shows as sent to external. but the status in the WE02 is still the same.
what else i have to check for ?
thanks in advance
nikhil bos
User | Count |
---|---|
88 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.