on 11-30-2007 11:20 AM
Dear Experts,
Could any please replay me for the below issue
I have released Net forecast from DP to R/3 for a particular product and I found message in job log as "Successful transfer to R/3". But there is no forecast figures in MD62 or MD63.
what might be the reason behind that?
Thank you
Hi Sriramulu,
Following are the points that you have to consider while releasing the data to R/3 from DP.
Checks in APO
1. Product and location should exist in APO.
2. Planning Book/Data view should have a Time bucket profile with one periodicty
3. Distribution defination should be setup on APO. the following is the path to set this.
SPRO > IMG> Advanced Planning and Optimization --> Basic Settings --> Integration --> Publication -->Maintain Distribution Defination
Specify "Planned Independent Requirement" and the location(Plant) for which you are transfering PIR and logical system.
Checks in R/3.
1. MRP Type in Material Master should be X0 (MRP1 View)
Best Regards.
Raghu Kishore
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please also check whether product, location exist in APO as master data.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Sriramulu-
there might be couple of issues
1) have you set up the publication rules for transfer of PIR? if not then try to take a look into that by using SPRO (has to be set up for each location)
2) check the RFC destinations and user passwords that might have expired.if yes then reset it.
Regards
Suresh Garg
Message was edited by:
Suresh Garg
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I think you need also to maintain the "Maintain Distribution Definition" per location in SPRO!
Gave me a headache several times...
Regards
Stefan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Also check in MD74
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi ,
I hope you have done all the Prerequisite settings as below :
.have set up your products in SAP APO
.have set up your locations in SAP APO
·have created a data view for this task in SAP APO.with
¡ future planning horizon only
ii planning buckets profile with one periodicity only
iii Only the key figure(s) that you want to transfer to SAP R/3
.have set the planning strategy of each material in SAP R/3.
This should transfer the data without errors and also please check the same in MD04 if you can see it there..
Regards ,
Digambar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
8 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.