Confirmation Parameters - Checks are not working

[Former Member]

Hello Champs

I am facing an issue with COnfirmation Paramaters -

System is not reacting as per my config done for confirmation parameters--Pl see below and suggest

My Config settings in OPK4 (Parameters for order confirmation )

<b>General Valid Setting</b>

>> Error when operation sequence is not adhere to during confirmation

<b>

Individual operation entry with the initial screen</b>

>>> SELECTION - Check for confirmable operations

<b>all checks for Propose data to be confirmed</b>

But When I am executing the CO11N

System is not proposing the confirmaable operation , rather its giving <b>error</b> <u><i>sequence 0 operation not found</i></u>

so i have to select the operation manually..and even if I Put operation 20 before operation 10 and confirm , system is not giving error ..

its saving and posting the GR also.

Could you pl suggest some solution for the same..as i think my all config settings are fine in confirmation parameters..can you think somehting else..

BR

Sumit

[Former Member · Accepted solution]

Hi Sumit,

The settings what you have done are correct, please check with control key that has been assinged to your 20th operation.

if u want to get error message, while skipping confirmation of first opeartion, set "confirmations" = 1 ,for the control key of 20 th opeartion at OP67 .

Please try and comeback.

Regards

pradeep

[Former Member · Accepted solution]

Hello

Thanks for reply..

I am already having this setting in my control key .. (its confirmations=1 ) in my control key..

any other suggestions

[Former Member]

Can any one share some thoughts on this Please?

BR

Sumit