Idoc to edifact

[Former Member]

Hi all,

I need to convert an INVOIC2 idoc to an EDIFACT file format using SEEBURGER's VAN adapter.

Please help me out with the VAN adapter configuration.

When I search for the VAN adapter, the search results contain only the information about the VAN network (value added networks) but no info about the VAN adapter is available.

Please help me with this case.

Its very urgent.Also send me the ALE settings needed for the source IDOC both in XI and R/3.

thanks in Advance.

[Former Member · Accepted solution]

HI Rambabu,

I think I have given you the VAN adapter information and the configuration which needs to be done for the same.

Have you refer my thread which signifies the configuration for AS2 adapter you need to follow the same for the sender and receiver adapter.

Please go through the thread again It will help you.

I have also given you the module name which needs to be put in the adapter module for the conversion.

See_X2E_INVOIC_UN_D96A

See_X2E_INVOIC_UN_D99A

IDOC configuration :

This is expalined both the scenarios:

Refer the help:

/people/swaroopa.vishwanath/blog/2007/01/22/ale-configuration-for-pushing-idocs-from-sap-to-xi - ALE settings for R3-XI

https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/e07dcaa0-a92b-2a10-3a96-b3d942bd...

Please follow the below process for configuration:

Pre-requisites for Inbound IDoc to R/3 from PI:

Configuration required at Xi side:

Go to IDX1: configure the port.

Go to IDX2: load the DOC metadata.

Go to SM59: Create RFC destination which points to R3 system this is require in the case where your IDOC is sent to R 3 system,

Configiration required at R3 side:

Maintain Logical System for PI (SALE transaction):

Maintain Partner Profile for XI system(WE20):

Pre-requisites for Outbound IDoc from R/3 to PI:

Configurations required in R/3:

Maintain Logical System (SALE)

Define RFC Destination (SM59) which points to PI system

Maintain Port (WE21)

Maintain partner profile. (WE20):

Maintain Distribution Model (BD64):

Thanks and Regards,

Chirag Gohil