on 11-23-2007 2:51 PM
Hi,
in PO creation system doesn't show condition PB00 in view condition
(gross price) if there is not a recordinfo for that material/vendor.
I would set that automatically system propose PB00 without any
recordinfo.
Is this possible?
Best regards
Answer is "NOT POSSIBLE". Because, PB00 is automatic condition due to its nature (requirement attached) and by its definition, is assigned to access sequence. Only when you define condition master record, it can call automatically in to the document ....By any means you want to enter manually in the PO, it automatically uses PBXX and at any point of time either PB00 or PBXX only can exist. Hope, this helps!
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Check in the schema condition if exits the condition PB00
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.