cancel
Showing results for 
Search instead for 
Did you mean: 

Unable to chose the Correlation name from Drop Down

Former Member
0 Kudos

Hi Experts,

I have a BPM in which I am have the following scenario.

1) I receive a message in BPM using a Rx step.

2) I send the message to some receiver with two Correlations(Say correlation1 and Correlation2) activated.

3) I get an acknowlegdement signal which uses Correlation1. This closes Correlation1.

4) Later I receive another Signal which will close the second correlation.

The problem is that I am unable to chose the Correlation2 in the drop down for Use Correlation in my step 4. Immediately after chosing the correlation and saving, it is resetting to space and giving an error in syntax check that Correlation is not done.

Can someone help me in this regard?

Regards,

Ravi Kanth Talagana

Accepted Solutions (0)

Answers (1)

Answers (1)

prabhu_s2
Active Contributor
0 Kudos

for single recv step its enough u use just a single correlation. u troubleshoot the error by inserting another recv step and desgin the ip accordingly. i hope in this case u wont have the eror triggered while activating