on 11-16-2007 4:55 AM
Hi
Is it possible to change the depreciation key for an asset which has already been created and manual depreciation posted to it. We have tried to change but the depreciation key is shown in the display mode.
We have also tried to change the config of dep key and saved the dep key. But the system is not showing the planned values as per the new config of dep key. We have not run any dep cycle for the asset.
Regards
Sanil Bhandari
Hi Sanil,
As far as i know, It is possible to change the dep key eventhough the manual depreciation has been posted to it.
The depreciation key that shown in the display mode like you said, Is it also happen for depreciation area 01? I meant , the depreciation key for depreciation area =01 also cannot be changed?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi,
1. You can change the depreciation key in the Asset master (AS02) even if manual entries have been posted to it.
2. Now if your values are appearing correctly in Asset Explorer in planned data
then you need to run AFAB again and remove the "Test Only" check and run it
again for the values to be posted.
Hope this resolves your issue.
Assign full points if useful.
Rgds
Prasad.
is it an sub-No.?
fi you've changed configuration , recalculate depr. with tcode afar
A.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.