on 11-14-2007 4:22 PM
Hello!
I would like to implement an urgent correction in CharM within SAP Solution Maanger and have problem to set the correction in status "Pass correction to test".
The warnings I have are:
1)<b>Status was reset by system</b>
SOCM_ACTION_LOG097
2) <b>Unable to find a change in development system</b>
Message no. SOCM_ACTION_LOG008
As result I cannot proceed in QAS system in Tak List, because the tasks there are locked.
Any helpful information will be appreciated.
My configuration is:
SRM-000 (Test) (system role: source)
SRM-001 (Customizing) (system role: target system)
SRM-100 (Production) (system role: production)
P.S.
The scenario I implement:
For the user X in DEV client (in my case 000) create a role via PFCG, let's say "Z_allow_tcodeSM13", transport these role to QAS client (client 001)and after succesfull test into the PRD client (client 100).
Thank you very much!
regards
Thom
Hi Thom,
did you release the task and transport?
regards,
Jason
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello!
Thank you very much for your response.
I just went through the tasks in Maintenance cycle within the urgent correction for source system.
I have at the end two steps with same name "Import Support Package", the first was green the second yellow.
The last task "Release ..." is also green
When I go back to Urgent correction and try to to set in test, I get two warnings and cannot proceed.
Thank for your further help.
P.S.
The scenario I implement:
For the user X in DEV client (in my case 000) create a role via PFCG, let's say "Z_allow_tcodeSM13", transport these role to QAS client (client 001)and after succesfull test into the PRD client (client 100).
Regards,
Thom
User | Count |
---|---|
84 | |
24 | |
12 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.