on 10-31-2007 8:56 PM
hi
In my 5.0 Pl Book, I am unable to enter a value '0' in a cell. Sooner i enter, it disappears for blank. In my PA, under KF details, its ticked for 'Zero Allowed'. But still, i am unable to enter 0 value.
How can i enter this and also i want to fix it later. (Even the KF is configured as Fixable Zero.)
thanks
Venkat
closing the thread. Thanks to all.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
thank you all.
venkat
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Venkat,
Please apply the lastest SAP GUI 6.40 patch 23 and special binaries fromthe SAP Note 889989. If the problem is not solved then please read
information about SAP GUI 7.1 in the SAP Notes 147519 and 950052.
Regards.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
May i know the OSS notes no.
thanks
venkat
Message was edited by:
venkat babu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
If you upgrade your GUI to 7.10, u can see the Zero's in the cell. There is a OSS note available on this problem.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
My experience...
When you said 0 allowed.. in that Key figure you are allowed to enter 0. and System will read it as as 0 and not as a blank value.
After saving the 0 value you are not able to see 0 value in that cell.
System will recognise it diffrence between 0 and blank value but not user.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
8 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.