on 10-26-2007 10:29 AM
Hi All,
We are triggering Manual Rework order after confirmation for rework in production order confirmation (CO11) .
Issue No. 1 :Rework order created is not having material refrenece.
Issue No. 2: No inspection lots are created for rework order .
I have maintained 03 inspection characterstics in quality view of material master & Order type dependant parameter for rework order.
Please guide.
Sipra,
issue No 1
Are you using trigger points & reference operation set to create the rework order?If yes then it will create order without material reference only
Issue No 2
I think as there is no material reference,the inspection lot is not getting created
Any way I believe,If the inspection characteristic is maintained in the material master that itself should trigger the inspection lot creation
Is it also necessary to maintain in OPL8?
Revert me back if u have other opinion/views
Reward points if u find useful
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Sipra,
If you want to use reference operation set,trigger points then the order will get created only without material reference,So if u want inspection lot to be created for the rework order material again then i think its possible only manually,If u have found out any alternative to overcome this let me know
Hi Sipra,
Also, input the inspection type in the Rework order dependent paramters through T.code OPL8.
Reward if cleared and close the thread.
Keerthi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
89 | |
7 | |
6 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.