on 08-26-2005 11:40 AM
We have a File->XI->IDOC scenario.
Two different types of files have to been mapped to the same IDOC (WMMBXY).
We want to use the field MESCOD in order to differ idocs from one type file or the other.
In the Message Mapping, I have the EDI_DC40 record dissabled, to permit that it is fulfilled by XI.
How can I put information in MESCOD field?. Is the only solution to enable EDI_DC40 record ? (I don't like this solution because automatic fulfilled is lost ).
I've seen that a Header Mapping exists in Receiver Agreement, but this is only available to Sender&Receiver.
Thank you.
Francisco.
hi Francisco,
take a look at this:
http://help.sap.com/saphelp_nw04/helpdata/en/13/95244269625633e10000000a155106/content.htm
section:
The following table provides information about
how the fields of the control record are filled by the
receiver IDoc adapter.
now you see which fileds are supplied by receiver idoc adapter
then:
If you have not set the Apply Control Record Values from
Payload indicator in the receiver IDoc adapter, the
fields are filled as follows:
now you see which fields are taken from ID
so enable EDI_DC40 and just fill MESCOD
this will be much easier than any other routing
(if such exists if you disable it)
Regards,
michal
Regards,
michal
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Francesco,
Check this "How to Guide"
How To Sample IDoc Scenarios within XI3.0
Regards
Vishnu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.