on 10-25-2007 3:52 PM
hi , IT'S URGENT,
We are using ONLY one INBound interface , Interface MApping , Message MAPPing .(no cahnges in IR)
IN Integration Directory We have to route to 2 FTP servers based on Company code .
WE have used XPATH with particular company codes TO one target Business service which we have created in ID where we are using one FTP server(FTP server 1).
For all other company codes it has to send to second FTP server for Second business system which has been created in SLD .
As now we created now .
One receiver determination
Two Interface DETERMINATIONs(As enhanced type).
Two REceiver Agreements.
As now we have tested
it is sending all files to both servers.
But we need to send to specfied FTP servers on the basis of COmpany code which we declare in XPATH expression.
POINTS WILL BE REWARDED FOR BEST ANSWERS..It's urgent
THanks in ADvance
Nandan
Hi Guys ,
I have same scenario, But i made two Message interfaces and Two Interfaces mappings(eg : one for Plant1 and another one is Plant2) -
IR
ID :
--
2 communication Channels ( one for Plant 1 and another one is Plant 2)
Add 2 reciver determinations
Add 2 interfaces determinations ( here you need to set up Conditions) based Plants
Finally 2 receiver derminations.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
put the condution on the interface determinaino (condition tab) this will alllow yoy to selct the Xpath and give check the value of the CC here.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hey
>>Two Interface DETERMINATIONs(As enhanced type).
any reason why u are using enhanced interface determination?
you have two different receiver BS,u just need to give conditions in Xpath and use standard interface determination
also check the conditions in Xpath again,a lot of times it happens that some element is mis-spelled or there is some mistake in conditions
Thanx
Aamir
thats strange,it should not do like this as long as all the configurations have been done correctly,try doing a cache refresh and try using standard interface determination,secondly check the configuration in ID,make sure all the objects are activated in IR(specially message interaface) and also in ID make sure that u have selected correct message interaface.
thanx
User | Count |
---|---|
84 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.