2EETW000 I have some problems during TADIR access

[Former Member]

Hi,

We are trying to configure STMS on our sandbox ECC 6.

We have created the same system as domian controller and created a

virtual system.

We established standard configuration-> Development production

transport paths between them.

When we are saving it we are getting a message stating the Change and

transport system is not configured.

We checked TMS : Check Transport Tool and there observed the following

Check Transport Tool

24.10.2007 15:42:40

ZPE System ZPE

tp Interface

Transport Profile

RFC Destination

tp Call

RFC Link tp was started successfully

tp Version 372.04.04

DB Connect Link to database failed

Offline Call SAP-System not installed properly

(HEA..

The log contained the following..

This is tp version 372.04.04 (release 700, unicode enabled)

HALT 20071024154239

ERROR: SAP-System not installed properly. (TADIR HEAD SYST missing.)

ERROR: EXIT(16) -> process ID is: 4744

tp returncode summary:

TOOLS: Highest return code of single steps was: 16

ERRORS: Highest tp internal error was: 0233

standard output from tp and from tools called by tp:

We have checked running r3Trans -d and it ended with a message as

follows...

This is tp version 372.04.04 (release 700, unicode enabled)

HALT 20071024154239

ERROR: SAP-System not installed properly. (TADIR HEAD SYST missing.)

ERROR: EXIT(16) -> process ID is: 4744

tp returncode summary:

TOOLS: Highest return code of single steps was: 16

ERRORS: Highest tp internal error was: 0233

standard output from tp and from tools called by tp:

We have checked in TADIR table and we could not find any entry for

PGMID: HEAD OBJ:SYST where as in the other system where STMS is working

fine we identified an entry.

Please suggest.

Thanks & Regards

Mrutyunjay

[Former Member]

We have reinstalled the system..

but after a while SAP came up saying a direct update to TADIR table at database level..

Mrutyunjay

[andreas_herzog]

transaction SE06 done successfully?

tansaction STMS as well?

what about trabsaction SICK/SM28?

GreetZ, AH

[Former Member]

Hi Andreas,

Yes, I have gone through SE06, STMS.

SICK/SM28 shows as "No errors reported"

Please let me know is the entry of for OBJECT: SYST in TADIR is manadatory.

Then how can we register a new OBJECT so that the entry goes into the table.

Thanks & Regards

Mrutyunjay

[Former Member]

Hi,

As per the post

I have tried the FM TR_TADIR_INTERFACE but it is also throwing an error message that "Change and transport is not configured" and stopping.

Please suggest.

Thanks & Regards

Mrutyunjay