Error in Wage type

[Former Member]

We have configured a new wage type Car Running Allownace-1CR0 under

wage group type 14.

When we are maintaing thru PA30 amount in Car Allownace in Infotype-14,

system is giving following error message -'Termination in operation

ERROR 20070367. X025 -

---

ERROR--Basic entry in IT.

Can anyone suggest reason for the same.

With Rgds.,

Rakesh Kumar

[Former Member]

Hi Kumar

The error is under rule X025 because specification for processing class 4 is blank for wage type 1CR0.

Meanwhile please check that the configurtion of this wage type and see If the wage type is configured with indirect valuation module (View V_T511) such as INVAL A, then its fixed amount can be maintained at view V_T510. Again, this configuration could be done for different Allowance Grouping with different fixed amounts.

It is also possible to configure different wage types for different Allowance Grouping and assign different valuation method and/or values for each of them.

Please note that Allowance Groupings are dependent on payscale parameters (payscale

group, payscale type, payscale area, payscale level) and Employee subgroup grouping for cumulative agreement provision. Please refer to the documentation 'Indirect Evaluation' topic for further details.

Hope above can help you

Regards

Jun

[Former Member]

Hi Jigal,

In P.C. 04 you should give a value.

if it has no value you'll recieve an ERROR message.

hope this helps,

moti