LifeCycle : /SAPAPO/RMDP_FCST_AGGLC_CUST

[Former Member]

I wanted to run this report /SAPAPO/RMDP_FCST_AGGLC_CUST.

But when I execute this in the menu bar it says "Transaction /SAPAPO/RMDP_FCST_AG" does not exist.

I also tried with /n/SAPAPO/RMDP_FCST_AGGLC_CUST

Any suggestions ?

Raj

[Former Member · Accepted solution]

Hi Raj,

This is not a transaction code which can be run directly from Menu.

Go to SE38 --> Enter the program name "/SAPAPO/RMDP_FCST_AGGLC_CUST" and then press F8(Execute) button.

When you try to enter this in the Menu as a transaction, the program name is truncated to 20 characters(from /SAPAPO/RMDP_FCST_AGGLC_CUST to /SAPAPO/RMDP_FCST_AG) and hence its giving you an error msg that TCode not found.

Best Regards

Raghu

[Former Member · Accepted solution]

Hello,

I am also on SCM 5.0 with SP 09.

Ok I tried to run it thro SE38 and it runs fine. But I am not sure does this mean that it is a program and ABAPer has to change it if required ?

I am trying to understand since SAP has given in their help that we can modify the system defaults with report program /SAPAPO/RMDP_FCST_AGGLC_CUST

Best Regards

Raj

[Former Member · Accepted solution]

Hi Raj,

This report is used to change the default settings of Life Cycle Planning.

By Default SAP sets the Maximum no of CVC to 1000 and No of periods to 52 for both Like planning and Phase in/Out profiles.

Go to SE38 and type in the name of the program and execute it.

In the following screen, you should see the maximum no CVC and Periods.

Provide the Planning Area name and change the maximum no of CVC and Periods according to your business needs. You do not require a ABAPER to do this as you will not change the code.

You can refer to 642593 note for information on this.

Best Regards

Raghu

[Former Member · Accepted solution]

Raghu and Anjali,

Thank you. This solves my doubt. I shall close the thread.

Once again Thank you very much.

Regards

Raj

[Former Member]

Hello,

I tried it on running on my system SCM 5.0 with SP 09.

It is working fine.

Can you please tell what is your SCM version and SP?

This report is not conected to any transaction code.

You will require to execute it via SE38 transaction.

Transaction /SAPAPO/RMDP_FCST_AG is also not present in SCM 5.0 system

from where you got this transaction refrence?