enable/disable - AT SELECTION-SCREEN OUTPUT
plz help me.
i need to disable a radiobutton after processing it.
i have done it using AT SELECTION-SCREEN OUTPUT but this makes the two radiobuttons in disable mode.
selection-screen begin of block block1.
parameters: r1 radiobutton group rad1 MODIF ID RR1,
r2 radiobutton group rad1 MODIF ID RR2.
selection-screen end of block block1.
if r1 = 'X'.
write: /10 'R1 Selected'.
falg = 'R2'.
write: /10 'R2 Selectred'.
<b> at selection-screen output.
if flag = 'R2'.
loop at screen.
if screen-group1 = 'RR1'.
screen-input = 0.
elseif screen-group1 = 'RR2'.
screen-input = 1.
it makes both r1 and r2 INPUT = 0.
but i have to make R1 alone INPUT = 0 after printing "R1 Selected" and after completing both the process both Radiobuttons has to be enabled.