Hi Doubt Regarding SPROXY Transaction

[Former Member]

Hi,

When i log on to my R3(>6.2) system with SPROXY transaction. i am not able to see the message interfaces witch i have developed in XI system, may i know the reasons. Do i need to configure anything between R3 and XI? and how to configure the SPROXY setting between R3 and XI? plz help me out.

thanks

dhanush.

[nisarkhan_n · Accepted solution]

Check the below blog this may point you in the right direction.

How do you activate ABAP Proxies?

also run this report in the R/3 and c what's the problem if all are sucessfull the you can c the interfcess fom SPROXY

SPROX_CHECK_IFR_ADDRESS -

---

OK Address maintained

SPROX_CHECK_HTTP_COMMUNICATION----- Connection Functioning

SPROX_CHECK_IFR_RESPONSE---- IB DATA understood

SPROX_CHECK_IFR_CONNECTION---IB DATA understood

also

Make sure that you have completed your entry in SLDAPICUST.

Do the following steps,

1. Transaction SXMB_ADM (refer to the Configuration Guide, chapter 5)

- Role of System: Application System

- Corresponding Integration Server:

dest://<your_sm59_http_destination>

2. Ensure that the RFC destinations LCRSAPRFC and SAPSLDAPI are

maintained and working (refer to the Configuration Guide, chapter 5.3)

3. Run SLDCHECK to verify that the connection to the System Landscape

Directory works.

4. Check that the Integration Repository is running and data is maintained there.

Message was edited by:

n Khan

[Former Member]

Hi,

Have you set up the folliwng in R/3:

1. SM59 destination SAPSLDAPI

This should point to your XI system.

2. SM59 destination LCRSAPRFC

This should point to your XI system

3. Transaction SLDAPICUST - Maintain access to your SLD data

4. Create SM59 destination INTEGRATIONSERVER - This should point to your XI pipeline

4. Transaction SXMB_ADM - Set up Integration Engine to use SM59 destination INTEGRATIONSERVER you have set up.

Try running SLDCHECK in R/3 and see what errors come up.

Cheers

Colin.

[agasthuri_doss]

Hi,

Sure there should be RFC Connection between the 2 system of type H

Regards

Agasthuri Doss

[Former Member]

Hi Doss,

Do i need to creat RFC type H in both the R3 and XI boxes for synch proxy. or onyl in R3?

thanks

dhanush.

[Former Member]

Hi,

You will need one in XI for your R/3 system and set up R/3 as I have already listed.

Cheers

Colin.

[agasthuri_doss]

Hi,

Create RFC Destination in R3 and select the connection H since it is proxy.

I hope the Connection between the two system will be there by Partner profile and port ..

Regards

Agasthuri Doss