Delta Mechanism : COPA extractor

[Former Member]

Hi,

There is one requirement in our project where we have to find possible reasons which can break delta mechanism in case of COPA extractor.

1.One reason is if re-alignment has run for the COPA datasource on R/3.Qusetion is: how can we find whether re-alignment has been run on r/3 side except indicated by data load failure? Is there any table which captures this information?

2. Any other possible reason which can break the delta mechanism in case of COPA extractor?

Regards,

Phani

[Former Member]

Hi,

See below link may it will help out you

https://www.sdn.sap.com/irj/sdn/forums

https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sapportals.km.docs/library/biw/g-i/how%20...

https://www.sdn.sap.com/irj/sdn/forums

[Former Member]

Hi Phanindra,

There is another very common error with COPA Datasources Delta Failure

Please see <b>my response</b> in below thread

Hope it Helps.

Thanks

CK

[Former Member]

Hi Chitrarth,

Thanks for replying but still did not have the solution for following question:

Is there anyway we could find it out if re-alignment has been done on R/3 system for CO-PA ? Any table capturing this information?

Regards,

Shiv