Error while RRI from BW reports to ECC CJI3 transaction

[Former Member]

Hi All,

When we try to set up RRI from BW reports to ECC CJI3 transaction, we get an error message (Stop message):

-

---

You cannot use the report-report interface to call up report RKREP000

Diagnosis

Line Item report RKPEP000 is not suitable for the report/report interface

Procedure

Always enter RKPEP000 as the receiver report for project line items in the report/report interface. This program uses the transfer parameters to determine which line item reports can be accessed.

-

---

<b>As per the other reply tried the ABAP Report RKPEP000/3 also ..no use ..

can you please suggest , how to go about this CJI3 issue for RRI , what settings need to be done in the RSBBS ...</b>

We have attemped to use "S_ALR_87013543" as well but the parameters don't go through properly which means when a user jumps from a BW report, they end up at the ECC selection screen of S_ALR_87013543.

Drill through is working for our Cost Center reports. Just not this one in particular.

Any advice would be greatly appreciated.

prasad

[Former Member]

Hi,

I'm facing the same problem so please If you have found some solution please tell me what should I do to use RRI from BEX query to CJI3 transaction.

Regards,

Ana