Skip to Content

Archived discussions are read-only. Learn more about SAP Q&A

Error in WBS Element Settlement.

Hi All,

when i am executing the WBS Element for Settlement in CJ88

i am getting the following error message:

<b>Either the sender is already settled, or there is nothing to settle</b>

Message no. KD213

Diagnosis

Possible causes:

The balance on the sender is zero.

There is nothing to settle for the settlement type selected.

Example: Periodic settlement

Distribution rule: Percentage rate 50%

Receiver cost center 1

Settlement type PER

Charge in the posting period: $200

Credit from earlier settlement: $100

The distribution rule always applies to the period value (here: $200). At the month end, 50% (here $100) was settled. This leaves nothing to be settled when the period close is repeated. The balance (here: $100) can only be settled using full settlement or an additional distribution rule.

can anybody seggest me the solution, very ugent.

i will reward the points for suitable answers.

Former Member
Not what you were looking for? View more on this topic or Ask a question