COPA Active in Operating concern

[Former Member]

HI Co specialists,

In sandbox created a co code and co area .

Defined Operating concern and assigned with CO area and co code.

But when I go to Maintain Contrllin (OKKP) the Profitability Analysis component is Not active.Whereas in Operating concern KEA0 is active.

How can I make the Profitability segmnet is active under OKKP.

I have not activated SD .Wil it be the reason?

Thanks, Chitras

[Former Member]

Resolved

Edited by: Chitras on Mar 13, 2011 8:18 AM

[Former Member]

Resolved

[Former Member]

The steps are:

1 create company code.

2 create controlling area.

3 Assign company code to controlling area

4 Create operating concern.

5 Go to KEA0 and generate the operating concern.(ensure that it is green)

6 Once u generate the operating concern u make the assignment to controlling area.

7 You can see the COPA active here.

I could able to do.

[Former Member]

I also face the same problem.

[Former Member]

Hi Kamal,

I did the steps given by you . I have already created co code and co area .Without COPA.

Then I created Operating concern by copying from standard and acivated

After creating the OP concern and activated both client dependent and clientr independent Icons. It became green after creating the environments.

Then I assigned the Operating concern to Co area.

After assigning on checking the Maintain controlling area it is showing still GRey and is inactive. It didnt allow me to make it active.

I have deleted the Operating concern and tried again. THe effect is same. What is the reason it is grey and am i missing anything..

Why it is grey all the time even after the Operating concern is active. I dont have created SD config in the system . Will it be a problem for this...?

Could you send ,the mail Id so that I can send you the scren shots if need be

THanks, Chitras.

Message was edited by:

Chitras