on 09-25-2007 2:28 PM
Hello all,
In my webdynpro application i select a list of addresses. Dependent on selected address i would like to show an address with predefined component configuration.
Selection of addresses and show of an address are implemented in two components but in one application. I have definied configurations for each adress type.
Is it possible to switch the component configuration at runtime?
Or i must create two applications and after selection of an address start the second application with an application configuration?
Thanks
Regards
Paul
hi
good
go through this link
thanks
mrutyun^
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
unfortunately no reply...
I assume dynamic switch is no possible. Does it mean i must implement something similar like configuration via dynamic programming?
Regards
Paul
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.