APO DP - load from InfoCube to a 'fixed' cell in planning area

[Former Member]

I am using APO DP V5.

Suppose I have a key figure which is fixed for a particular time bucket cell.

If I try and load data into this cell from an InfoCube, what will be the effect? I assume that the cell will NOT be udpated.

Regards,

Bob Austin, Atos Origin

[Former Member · Accepted solution]

Hi,

Fixing information will be

extracted when saving the data into an InfoCube and will be reloaded

when using transaction /SAPAPO/TSCUBE to load the data back into the

planning area. If you load the data back only on the level of the

basis planning object structure, the data will be aggregated to the

level of the aggregates but no fixing information will then be

available on the level of an aggregate.

and also /sapapo/tscube doesn't check fixing info in LC when data is written to LC. In case there is fixed data in iCube, that fixing info will be loaded into LC.

You can also refer the note 1057308.

Regards,

Srikanth.