Application and Component Configuration

[Former Member]

Hi all

I have a application component (component without view but with application) and

several other components with views (but no applications). the view components are "used" by the application component.

I created an application configuration and view component configurations (implicit).

The view component configurations set some fields in the view to "read only".

In the application parameters i use "WDCONFIGURATIONID" to set my

application config.

My problem: The application starts but the fields are not set to "read only".

What am I missing?

Thanx

Paul

[Former Member]

I am doing application and component configuration (as described above) and

NOT personalization.

Thanx Paul

[Former Member]

Hi,

How did yo solve it? I have the same problem trying to do it with web dynpro component RPLM_QIMT_NOTIF_COMP.

Component RPLM_QIMT_NOTIF_MAIN_COMP has application without view.

Component RPLM_QIMT_NOTIF_COMP has view and no application.

Component RPLM_QIMT_NOTIF_MAIN_COMP uses component RPLM_QIMT_NOTIF_COMP.

In an easy example configuratioin is ok, but in this case I don't know how to do it,

Any ideas?

Thanks.

[former_member196517]

are you doing this in admin mode ?

[Former Member]

Hi Anuj

From a Developer Persepective:

Configuration of Web Dynpro application or of a Web Dynpro component takes place always at design time from within SE80 with the "configurator" which

is a web-application.

That's why I do not understand your question about "admin mode".

Regards Paul

[former_member196517]

Hi Paul,

apologise for confusion.. are you doing personalisation or setting application configuration...

for personlisation

go to transaction se80 webdynpro application .. go to toolbar above-->webdynpro application -->click on test --> execute in administrative mode... now do your implicit personalisation and see if it persists

Can you try

regards

Anuj

Message was edited by:

Anuj Goyal