Syntax error in program SBDLS after CU&UC

[Former Member]

We performed an CU&UC from 46CMDMP to ECC6 Unicode.

In the target system the BDLS doesn't work.

We recive the error:

"Syntax error in program SBDLS ..........." trying to run it in dialog or batch.

The report attached to the tx BDLS is correct.

Any advise ?

[Former Member · Accepted solution]

Not clear on the actual cause of error. Did you complete SPUMG/SUMG steps ?

What's in ST22 dumps ?

[Former Member · Accepted solution]

No dumps in st22 or into the SM21

[Former Member · Accepted solution]

Hi roberto mariani,

I got now also this error message in transaction "BDLS". What was your solution for this problem?

Syntaxfehler im Programm SBDLS00720090402115607 line SELECT SINGLE AWSYS FROM DFKKKO

Many thanks and best regards

Marcus

[rahul_bhavsar · Accepted solution]

Hi,

I am also getting same error after CU&UC.

"Syntax error in program SBDLS09020090804133244 line SELECT SINGLE AWSYS FROM DFKKKO"

What is the resolution ?

Thanks

Rahul

[andreas_rogge3 · Accepted solution]

Hi All,

I had also this error after system copy from PROD to TEST. Solution from SAP:

--> re-activate the tables DFKKKO and DFKKMKO through the transaction SE11

( SE11 -> display -> menu 'table' -> activate )

And it works ...

greetings

Andreas

[Former Member · Accepted solution]

Dear Andreas,

we have had the same issue!

Thank you very much for your solution!

Regards

Florian

[former_member184709 · Accepted solution]

Nice work Andreas.

We also had this error and your workaround fixed it.

System:

4.7 to ECC 6.5 CU&UC upgrade (single code page)

[Former Member · Accepted solution]

Hi Andreas,

We have the same issue and by re-activating the tables DFKKKO and DFKKMKO, it is fixed. Thanks for the solution.

Regards,

Surendra