on 09-10-2007 2:53 PM
hi experts,
plz help me
smartforms page print two sides not dublicate and threeble cate continue paragraph
in second page also plz help me any body.
thank one and all.
Hi,
Go to SPAD ,
take output devices .
Choose your output device ,
double click
take the output attributes.
Give the print mode as Duplex.
Your printer also should be set for the duplex mode.
Regards
Sudheer
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Different settings are required for duplex printing, depending on whether you are printing SAPScript/Smart Forms documents or ABAP lists.
Information about whether output is on one page, duplex, or tumble, is specified in the SAPscript/Smart Forms document
The following print controls are used to control duplex printing:SPMBU
Begin DUPLEX mode (that is, print on both sides of the page starting with this page)
If the SAP device definition for your printer does not contain the print controls, told above
a) COPY the device type
To copy a device type, do the following:
1) Start the spool administration function by choosing Tools --> CCMS -->Spool --> Spool administration.
2) Choose Utilities --> For print control --> Copy device type to copy the definition of an output device.
Enter a name of your choosing that begins with a Y or a Z.
3) The SAP System copies all of the following when you copy a device type:
The device type definition.
The print controls defined for a particular device type. (You can add to the list of standard print controls, however, without restriction.)
The device format
SAPscript printer fonts and printer bar codes defined for the device type.
b) Add the required Print Controls and enter the printer-specific escape sequences Look in your printer manual for information about what to enter.
To add new print controls to a copy of a device type, proceed as follows:
1) Select Tools --> CCMS --> Spool --> Spool administration --> Full administration. Enter the name of the device type in the Device types field and confirm your input.
2) Choose Print controls.
3) Choose Std print controls to select the print control you want to add to the device type definition.
c) Create an output device with the new device type.
You can Basis help to do this set up.
Regards,
Sairam
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
In output options of your page..check print mode.
It might be set as Duplex
This can be done at the page in smartforms itself
Message was edited by:
Nehal Fonseca
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi
nothing is needed here
u just change the printer settings u keep the output in a duplexmode
regards
ss
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.