Planning area data not matching with backup cube / PSA

[Former Member]

Hi friends,

while loading data from planning area to backup cube , for the key figure ( result of a macro),the data in planning area is not matching with PSA as well as with cube.

At the same time Data is matching at total level but not at disagregated level. And many times it disagregate in equal Proportion in cube/psa.

Pls its urgent.

Pts for sure.

Vishal.

9326179903

[Former Member · Accepted solution]

Goto RSA6 and do a test extraction on your datasource with your selection. And verify that the data matches with the data you see in the planning area.

[Former Member · Accepted solution]

Hi,

Please do the data consistency check at planning area first and then do the RSA6 related simulation to check that it is working fine or not.

[Former Member]

make sure you have replicated the extraction of the data source. This is needed to ensure your backup cube gets the current data as in the planning area

if you got to /SAPAPO/SDP_EXTR then you can see this button

you can set this up as a program scheduled to run before the updation of your cube

As for the disaggregation, test at what level you are choosing your characteristic? ( i suppose you can choose the level)

Are you extracting at a detailed level or at the aggregated level

Is your macro saving the data into a Keyfigure or is it an auxilliary KF or something?

[Former Member]

Thanx for reply.

Ya , the macro result is saved in Key figure.

And while extracting that Keyfigure,the values in PSA not matching at disagregated level. In PSA/Cube data disagregate in EQUAL Proportion.Why?

/SAPAPO/SDP_EXTR progr is not there in SE38.pls tell where to check?

thanx

vishal

[Former Member]

its a transation ... not a report

you can also go to Administration of Planning area and in the toolbar choose Extras and Maintain Datasource (i think- choose the last option)