ADS form error

[former_member214272]

Hi,

I am working in c project, When I am trying to approve the phase I face the error given below.

I have done all spro setting corectly then also I am facing the problem

You cannot begin approval pl approve without an approval document

Message no. DPR_APPROVAL025

Diagnosis

The approval document for approval pl approve could not be created.

System Response

The system cannot begin the approval.

Procedure

Check in Customizing for Collaboration Projects whether a print form for the approval document has been assigned to the project type of your project, by choosing Activate Forms per Project Type . The print form must be active.

Contact your system administrator.

Procedure for System Administration

Check the print form you are using.

<b>When system enviroment is 4.7 r/3 and c project suit 4.00 it works fine.

when we upgrade the 4.7 to ecc6.0 that error comes.</b>

<i>ABAP stacks needs connection to ADS to display the form. So we need to create HTTP Destination on J2EE where ADS is installed.

can you guide me how to check that ABAP stacks connection to ADS & how to check HTTP connection with J2EE</i>

THANX

SUNIL JAWALKAR

[former_member191062]

Dear Sunil,

this is an application not an ADS error message. You can check the ADS configuration as described in SAP note: #944221

Best regards,

Dezso

[former_member214272]

hi dezso pap

your information is very helpfull for me

thanx

sunil jawalkar

[Former Member]

hi ,

this is late reply but can solve others problem.

assigne copy of role SAP_CPR_PROJECT_ADMINISTRATOR and generate it .

also check for following settings

1) Please set the print form DPR_APPROVAL_HIER for the phase type in customizing:

SPRO -> Collaboration projects -> Structure -> Define Phase Types

2) In cProjects, you have to assign the print forms to a specific project type - in your case.

SPRO -> Collaboration projects -> Basic Settings -> Forms for Printing and for Project status reports -> Activate Forms per project type.

PDF Print Form:

Please enable the flag for DPR_APPROVAL_HIER for the project type. And deactivate the flag "Status report" for DPR_APPROVAL_HIER.

Smart Forms Print Form:

Don´t enable the smartform DPR_APPROVAL_HIER for the project type.

As with cProjects 4.00 the smart form approval document is no longer supported, the PDF Print form must be used instead

and note for PDF settings 944221

Regards,

Nitin Salunkhe.