on 08-27-2007 1:29 PM
Hello all,
How do we configure the delivery output say 'LD00' so that the same should be printed once the Transfer order is created say via Vl06.
We have attached the output say Z196 to the output and have put a requirement routine, which would attaching the output only when the TO is created. Though the problem i am facing is that when the TO is created via Vl06, the output is not getting attached to the delivery and one has to manually go into the delivery in the change mode and then only the output is attached.
Let me know the work-around for this
Thanks and Regards,
gaurav.
you can put the requirement with modification that the item should be TO releveant and check for PGI , so that it gets fired once the delivery is thru
reward if useful
rajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
That requirement is already there.
The issue is that the delivery output is not read by the system, when we do picking from VL06 to create the Transfer Order.
Thus, the output is not attached to the delivery and is not printed.
I am looking for as to how the output can be attached and printed out when we do the picking via transaction Vl06.
Thanks and Regards,
Gauravjit.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.