on 08-25-2007 9:15 AM
Hi All,
I have a scenario which looks like
<b>Source R/3 --> Source XI --> Destination XI --> Destination R/3</b>
I need that the XI to XI conection was done with XI adapter. Could somebody give me the steps? In SLD, Builder Desing and Builder Configuration?
Thakns in advance
Regards
Vikas.
hi
Source R/3 --> Source XI --> Destination XI --> Destination R/3
Follow the bolow steps:
In XI(A):
Create BS (as XIB) for your XI(B) in your XI(A).
Create CC for this XIB in XI(A) and use XI adapter.
Use TransportProtocall: HTTP
Message Protocall: XI3.0 (depends).
AE: IS
Address type: HTTP Destination,
HTTP Destination: HTTP_XXXX (create in this using sm59 and type H)
Use ur normal RCVR Determinaation, interface determination and RCVR aggreement. but ender agreemnet is not required as sender is R/3.
In XI(B):
Create ur BS for Destination R/3,
Create CC for Destination (R/3) in XI(B) and use adapter like RFC, IDOC and XI(If it is through Proxy).
Use ur normal RCVR Determination, interface determination and RCVR aggreement. but ender agreemnet is not required as sender is R/3.
reward point if helpful
regards
sreeni
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
SLD: config two BS
Use adapter like: RFC Sender\XI Receiver; XISender\ RFC Receiver
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.