on 08-21-2007 6:41 PM
HI,
when i set a limit to my condition types that are used in the pricing procedure, I cannot manually change the value of that condition in the sales order....even if the new value lies in the limit.eg. if my limits are 2.000 and 8.000, and my sales order entry is 6.000, the message goes like this.."6.000 falls below the limit 2.000- for condition type xyz"
Even if I delete my condition limit entry, I still keep getting the same error message whenever I try to change my condition value in the sales order.
Can you please give me a solution for this?
Regards,
Aditya
Hi Aditya,
Have you given the limits with a negative sign as 2.000- and 8.000-. If thats the case then the positive value of 6.000 is outside the limit. Just ensure you dont enter the negative sign or it not updated with a negative sign.
Regards
Nadarajah Pratheb
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi,
i dont find any reason why it should happen this way. just recheck this, remove the pricing limits first. So now you would be free to do any change.
Place limits now once again and make sure the limits are given as desired and save. try a fresh order again.
thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.