on 08-20-2007 8:14 PM
Hi,
I have installed BI Add-on component in ECC 6.0 IDES now which client will be source client and which we can consider as BI Client.Because in 800 client only i am able go to RSA1 tcode but there i cant able to active the source system please let me the solution
Thanks and Regards
Prakash B.
Hi
Not sure if you have resolved the problem..
Technically speaing you cannot have source and logical system the same..
Might be you can create a new client [900] and make that BW client and 800 as R/3 client.
RSA1 can be opened only in one client. Hence you need to change RSA1 to point to new client [900]
Regards
Madhu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
You need to take care of the following points:
- Maintain new RFC connection with <SID><client> [<client> is new BW client]
- Change the logical system for new BW client in T000 or tcode SCC4 with the new <SID><client>
- Enter this default client in the field BWMANDT of the table RSADMINA via transaction SE16.
Regards
Madhu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Prakash,
Create a new client and goto se37 and execute RS_MANDT_UNIQUE_SET to activate BI in new client.
Bi gets activated in new client than 800. You may need to change the logical sytem to new client if required.
Reward points, if helps
Arjun
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.