Adapter not in the monitoring

[Former Member]

Hello

I have a problem with sp12. I can not see the adapter in the monitoring. I now some people have the same problem in this forum. I have made all this steps. Then i have the adapter in the monitoring. I have use the program rsxmb_activate_icf_services.

After i reboot the sap system and the adapters was not in the monitoring. Then i start the program rsxmb_activate_icf_services again, put it is no more working.

Thanks for some help?

Regards Tom

[MichalKrawczyk · Accepted solution]

Hi Thomas,

take a look at question 3 (adapters section) :

/people/michal.krawczyk2/blog/2005/06/28/xipi-faq-frequently-asked-questions

then it will work:)

Regards,

michal

[Former Member · Accepted solution]

Hello Michal

Thank you for your answer.

I have an new installation with sp12. I have before reboot the system, the adapters. I try your solution, put it is not work.

regards Tom

[Former Member · Accepted solution]

Hallo Thomas,

if you create a new Communication Channel in Integration Builder Configuration, do you get the Adapter types shown or do you also have problems there?

Best regards

Christine

[Former Member · Accepted solution]

Hallo

Now, it is runnig.

1. First I clean the SLD Content with Note 764176

2. Check sld

3. Then I check the right for the xiafuser

4. Run the the programm RSXMB_ACTIVATE_ICF_SERVICES

5. Reimport the SAP_Basis softwarecoponent (Gudie from Michal)

6. Restart all adapter in the integration configuration.

Thanks for the help to all.

Regards Tom

[Former Member · Accepted solution]

Hallo

Now, it is running.

1. First I clean the SLD Content with Note 764176

2. Check SLD

3. Then I check the right for the xiafuser

4. Run the program RSXMB_ACTIVATE_ICF_SERVICES

5. Reimport the SAP_Basis softwarecoponent (Guide from Michal)

6. Restart all adapter in the integration configuration.

Thanks for the help to all.

Regards Tom