on 08-08-2007 12:34 PM
Hi All,
In my scenario the sender and receiver system message structure is same.
Is Message mapping is resuired....? if not please give me some inputs on how the data will be transfered ?
is their any difference from the typical configuration ?
How to design and configure the scenario.
Thanks,
Aravind.Pujari
Hi Arvind,
if sender and receiver message structures are same, then one datatype, messagetype would be enough.
in message mapping, select same message type both in source and target and do one to one mapping.
Alternatively, if it is file dumping, directly u can configure communicationchannels sender and receiver.....by the path u mention in CC file will be transferred.
Regards,
Ravi.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
If u just want to pass the data as it is, then mapping is not required.
And if u dont want any mapping, then u can avoid whole Integration repository step.
Have a look here
/people/william.li/blog/2006/09/08/how-to-send-any-data-even-binary-through-xi-without-using-the-integration-repository
Regards,
Prateek
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Message Mapping and Interface Mapping are not required in your case....though separate interfaces will be there in IR
In ID will proceed with the same way as u normally do
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.