Blank and Zero value in SCM 4.0 Demand Planning

[Former Member]

Hi Friends,

Is there any difference between blank and zero value in SCM 4.0 demand planning?

Is it possible to visually distinguish them in this release?

Thanks and Best Regards, Manoj

[Former Member · Accepted solution]

Hello Manoj -

Can you be more specific as to what you are asking about?

Regards,

Suresh Garg

[Former Member · Accepted solution]

Hi Suresh,

What I mean in case I have not entered any value in key figure in demand planning book then it should be called blank. If I have entered '0' (Zero) then it should be called Zero value. This zero value may come if I had entered some value, let us say 100, and later on deleted that value.

Thanks and Best Regards, Manoj

[Former Member · Accepted solution]

There should be an SAP note describing this zero feature. I am trying to find it without luck. Check the release notes as well. I will get back to you if I am successful.

Thanks.

[former_member788297 · Accepted solution]

Hi,

The differentiation between Zero and blank value is only possible from SCM 5.0

Regards,

Chava