pipe line steps

[Former Member]

Hi.......friends,

where we can see the pipeline steps?

Pls clarify this.Points will be rewarded.

Thanks & Regards,

Naresh.K

[Former Member · Accepted solution]

Hi..

Execute the Tcode SXMB_ADM..

you will find the option to see the pipeline steps..

Vasanth

[Former Member]

hi naresh...

see the below link....

http://help.sap.com/saphelp_nw2004s/helpdata/en/d6/49543b1e49bc1fe10000000a114084/content.htm

u have to set configuration parameter logging_sync and logging_propagation as 1.....

since pipeline steps occupy more memory normally logging is set to 0...

so,its better change it to 0...after u gone thru the steps...

Message was edited by:

sasitharan

[Former Member]

Hi

Pipeline steps can be seen at sxmb_adm

Go to sxmb_moni-->Go for pipeline element tap.Set logging to 0.

During pipeline processing the both design and configuration objects come into picture.

Generally 6 pipeline processing steps are :

1) Receiver Identification (**receiver agreement ) 2) Interface determination 3) Message plit, 4) Message mapping, 5) Technical routing 6) Call adapter

For more

http://help.sap.com/saphelp_nw2004s/helpdata/en/d6/49543b1e49bc1fe10000000a114084/content.htm

Thanks

[Former Member]

Hi,

You can get pipeline steps from SXMB_ADM.

1. In SXMB_ADM goto configuration-> display pipeline definition.

2.In pipeline definition give pipeline id as SAP_CENTRAL or SAP_CENTRAL_BACK and click pipeline element.

Regards,

S.RamNarender

[Former Member]

ref

YOu can see the Pipeline from transaction SXMB_ADM, one of the options is Pipeline.

But it just gives the details of the pipeline and not the step.

Ihe steps can be seen in the SXMB_MONI, if you go to any message and then go to trace inside, it gives the details of the steps the message has gone through.

Thanks

[Former Member]

>>where we can see the pipeline steps?

T.Code: SXMB_ADM->Pipeline Element Tap

Regards

[Former Member]

hi,

u can see the pipeline steps in SXMB_MONI

to see the pipeline steps u have to set the log level to 1...

to set log level to 1 ...u hav to go sxmb_adm...

then select integration engine configuration..

then select specific configurtion...

there set log level as 1

hope this helpful...