on 07-27-2007 5:54 PM
Hi,
I am testing configurations I have done in ID and it went all successfully but with one error stating <b>"Interface mapping not found , Runtime error
Unable to read payload from the message object"</b>
after going through some links in SDN ....
I did check the Interface mapping is active and the exact one used in the config.
and did all the chache refreshes in SXI_CACHE and Administration in te main menu of XI start page ,bbut no use.
in SM59 I checked INTEGRATION_DIRECTORY_HMI connection and I got
"Http : 500
Status Tex: Internal Server Error",
i understood from sdn links and readyness check check guide this is not a problem.
so what might be the cause?
thank you.
Babu
Babu,
Can you run your actual scenario and see it is successful or not. If you have any errors in communication channels or sxmb_moni post back here.
Regards,
---Satish
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Satish,
i got doubt ,do you think this is not a problem/
<b>in SM59 I checked INTEGRATION_DIRECTORY_HMI connection and I got
"Http : 500
Status Tex: Internal Server Error",</b>
cos,thats how communication happens between IR and Id right?if there is any error in INTEGRATION_DIRECTORY_HMI connection,I think it might be an issue,but readiness check guide says ok ,in the guide it has not been mentioned that "internal server error is OK""
any comments?
thx
Rajesh,
thank you,I have gone through that link already.
while testing my configurations in ID I am getting no interface determination found.
I havent given any payload in that test.
but still it shouldnt give no interface mapping found as I have active interface mapping in IR.right?
blog says "You can also paste a sample payload document into the Payload area; if you do not specify the payload, any mapping programs will not be tested.
"
but it doent not say like test would fail if we dont provide payload.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.